|
Output channels
|
2 |
|
standard
waveforms
|
sine, square,
triangle, ramp, pulse, DC and Noise. |
|
Arbitray
Waveforms |
|
Waveform Length
|
10 to 16384 points
|
|
Vertical
Resolution |
12 Bits |
|
Sample Rate |
16 MS/s
|
|
Nonvolatile
Memory |
four 16k
waveforms
|
|
Output Frequency |
|
Sine, Square
|
0.01Hz to 16 MHz
|
|
Triangle, Ramp,
Pulse |
0.01Hz to 1.6Mhz
|
|
Noise (Gaussian) |
MaximuM 8 MHz
bandwitdh
|
|
Arbitrary
Waveform |
0.01Hz to 1.6MHz
|
|
Resolution |
7 digits
|
|
Accuracy |
50 ppm
|
|
Output
Characteristics |
|
Amplitude (into
50 Ω)
|
50mVp-p to
10V p-p
|
|
Accuracy
|
±1(1%
of setting +5mv) at 1kHz,
Flatness
(at 1V aplitude relative to 1kHz)
<100
kHz : ±1%
100
kHz to 1 Mhz : ±1.5%
±1
MHz to 16MHz : ±3%
|
|
offset (into 50 Ω)
|
505 mVp-p to 10V
p-p amplitude: peak amp;itude + offset is limited to +5V or -5V .
50mVp-p to
500mVp-p amplitude: -0.75V to +0.75V
|
|
Accuracy |
±
(1% of setting +5mv)
|
|
Resolution |
5mV
|
|
Output Impedance |
50 Ω
|
|
Isolation |
42V peak maximum
relative to earth
|
|
Phase |
Range: ±360°,
Resolution : 1°
|
|
Sine Wave
Spectral Purity |
|
Harmonic
Distortion |
DC to 20kHz:
-70dBc.
20hz to 100kHz:
-60 dBc.
100kHz to 1MHz :
-45 dBc.
1MHz to 16MHz :
-35 dBc.
Total Harmonic
Distortion
20 kHz: 0.05% at
1V amplitude . |
|
Signal
Characteristics |
|
Square: |
Rise/Fall
Time : ≦20ns.
Overshoot :
<2%.
|
|
Pulse: |
Rise/Fall Time : <
100 ns.
Duty
Cycle: 1% to 99% of period.
|
|
Triangle, Ramp,
Pluse, Arbirary |
Jitter: 2 ns at
100 kHz
|
|
Modulation
AM: |
|
source |
Extternal
|
|
Carrier |
Up to 16MHz
|
|
modulation |
Any internal
waveform plus Arb.
|
|
Frequency |
DC to 200kHz
|
|
Depth |
1V: 100%
0V: 50%
-1V 0%
-2Vp-p for 100%
modulation
|
|
Modulation FSK
(Frequency shift keying) |
|
Source |
Internal only
|
|
Mode |
Trigger, Burst
|
|
Frequency |
0.01 Hz to 16 MHz
|
|
Key rate: |
0.01 Hz to 50 kHz
|
|
Number of keys |
2
|
|
|
Modulation FM: |
|
source |
Internal only
|
|
Modulation |
Sine, Square,
Triangle, Arb
|
|
Frequency |
01 Hz to 10 kHz
|
|
Deviation |
0.01 Hz to 8 MHz
|
|
Frequency Sweep |
|
Type |
Linear of
logarithmic
|
|
Direction |
Up or Down
|
|
Start/Stop
Frequency: |
0.01 Hz to 16 MHz
|
|
Time |
1ms to 100 s
|
|
Mode |
Continuous,
Trigger, burst
|
|
Operating Mode |
|
Continuous |
The selected
waveform is output continuously
|
|
Triggered |
One period of the
selected waveform is output each time a trigger occurs
Trigger source:
Manual, External
|
|
Burst: |
The selected
waveform is output with a specified number of cycles each time a trigger
occurs
|
|
Carrier
frequency |
Up to 1MHz
|
|
Count: |
1 to 60,000
cycles/burst (100 s maximum except sine wave or square wave) or infinite
|
|
Start Phase |
-360°
to +360°
Trigger source:
Manual, External
|
|
Inputs /
Outputs |
|
Front Panel |
Man output: Ch1,
Ch2
External Trigger
(Burst) input:
TTL input
Pulse width : 1 us minimum
10 kΩ
input impedance
|
|
Rear panel |
Sync output : TTL
Level
External Am
Modulation:
2Vp-p = 100% modulation
10 kΩ
input impedance
GPIB interface
(IEEE488.2)
|
|
Memory |
|
Type |
Non-volatile
|
|
Setup Storage: |
20
|
|
Arbitrary
Waveform storage |
4
|
|
ENvironmental
EMC, SAFETY |
|
Temperature |
Operating: 0°
to +50 °C
Nonoperating: -20°
to +60 °C
|
|
Humidity |
Operating:
At or Below +40 °C:
0 to 95%
+40
°C to 50 °C : 0 to 75%
|
|
Random Vibration |
|
Operating |
Operating:
0.31gRMS
from 5~500Hz 10 Min.
nonoperating:
2.46gRMS
from 5~500Hz 10 Min
|
|
Shock |
|
Nonoperating |
294 m/s2
(30G), half-sine, 11 ms duration
|
|
EMC compliance |
Meets intent of
Directive 89/396/EEC for Electromagnetic Compatibility.
Australian AN/NZS
2064.1/2.
|
|
Safety |
UL1244, CSA231,
EN61010-1, IEC61010-1
|
|
Power |
Line Voltage:
60 - 132 V, 180 -
250 V AC
Line Frequency:
90 to 250V : 48 to
63 Hz
90 to 127V : 48 to
440 Hz
|
|
Dimensions |
99 H *214W
*411D (mm)
|
|
Weight |
5.6 Kg
|
|
下載型錄(.pdf檔)